国产真实迷奷在线播放最新_亚洲日本午夜_内射无码91传媒_麻豆精品国产片在线观看_人妻系列无码不卡免费专区_午夜高清国产一区_可以播放的黄色网址_成年免费视频看片网站_91欧美精品在线视频_伊人久久中文字幕亚洲综合

聯(lián)系我們CONTACT US

Add: #850 Yatai Road, Xiaoshan District, Hangzhou, China
Tel:+86-0575-87562186

+86 13906740412 
Fax:+86-0575-87562186

E-mail:xsfld@vip.126.com 
Web.:zygq.com.cn

Elimination of common problems

發(fā)布者:TPS  更新日期:2018-08-30  點擊次數:2605次

First, open the software, the "control card can not open the" false Tis

Troubleshooting: 1, repeated open software;

2, control card (GOOgolTech400) driver is not installed.

Two, the Y1 axis returns to zero and in the process, appeared feeding cylinder to both sides ??販販販?

Troubleshooting: detection switch 1, the feed shaft, no signal is detected.

2, the system parameters, the single biggest feeding distance value is too large, the correct value is: 270.

3, the system parameters, the Y1 axis pulse equivalent error.

Three, X2 back to zero and in the process, appear slot mechanism to the upper and lower ends of ??販販販

Troubleshooting: detection switch 1, slotting shaft, no signal is detected.

Four, the A2 axis to zero, "the input port no input signal" error of Tis

Troubleshooting: bending cylinder below, two detection switch lamp does not light.

Five, in the process, "waiting for input signal" error of Tis

Troubleshooting: there is a bending mandrel play up, the detection switch of the bent cylinder above the lamp does not light.

Six, "S", both sides break Bdo

Troubleshooting: when the system parameters, the A2 shaft zero offset parameter error.

Seven, the material back to the reference point, the material has been on Sen

Troubleshooting: switch material reference point, no signal is detected.

Eight, in the process, "feeding shaft encoder is slippage phenomenon" false Tis

Troubleshooting: 1, material is not smooth;

2, in the system parameters, the feed shaft encoder pulse equivalent error;

3, the encoder and the material is not fully contact.

Nine, slot, materials do not have a complete Lady

Troubleshooting: 1, the direction is not installed on the knife;

2, in the user parameters, slot end position is wrong, the correct position is: _137.

Ten, the A2 axis back to zero, the bending shaft does not stop Chan

Troubleshooting: 1, control card failure;

The detection switch 2, bending axis, no signal is detected.